Journal Entry Automation: What Can Be Automated and What Still Needs Review
16 November 2026
Your close checklist has somewhere between 50 and 300 journal entries on it, and most of them look the same every month. The question is not whether to automate them, it is which ones, and what review is left once you do.
This guide splits the month-end entry list into what automates cleanly, what needs a person every time and the middle band where most of the work actually sits. It covers how to set a review level for each, a worked accrual example, the controls auditors will expect around automated entries and a five-step way to start.
What journal entry automation actually covers
Journal entry automation is software that prepares, routes or posts journal entries with less manual keying. Vendors use the phrase for three different things, and it helps to separate them before deciding anything:
- Generating the entry. Building the debit and credit lines from a template, a schedule or source data such as an open PO report, a fixed asset register or a bank statement.
- Routing the approval. Sending the entry to the right reviewer with its support, tracking who approved it and when.
- Posting. Writing the approved entry to the general ledger.
Most of the time savings are in the first layer. Most of the risk is in the gap between the first and third: an entry that is generated and posted with nobody looking at it in between. A useful working rule is that automation should take the preparation, never the approval.
Which journal entries can be automated
An entry automates well when its amount can be recomputed from a source a reviewer can open. If you can point at the schedule, the register or the report that produced the number, software can produce it too, and a reviewer can check it in seconds.
| Entry type | Where the amount comes from | What the reviewer still checks |
|---|---|---|
| Recurring fixed entries (rent, subscriptions, fixed fees) | Contract or schedule | The contract has not changed; the entry stops when the contract ends |
| Depreciation | Fixed asset register | Additions and disposals were entered in the register before the run |
| Prepaid amortization | Prepaid schedule | New prepaids were added; fully amortized items dropped off |
| Accrual reversals | Last period's accrual entry | Every accrual flagged to reverse actually reversed |
| Allocations and recharges | A set driver (headcount, square footage, revenue share) | The driver data is current |
| Bank fees and interest | Bank statement | The amount matches the statement line |
| Received-not-invoiced accruals | Open PO report checked against the AP register | Nothing was invoiced after the report was pulled |
| Recurring vendor accruals | Prior months of spend for the same vendor | Enough history exists; the pattern still holds |
The last two rows are where automation earns the most and needs the most care. A recurring fixed entry is trivial to automate and rarely wrong. A data-driven accrual is easy to get wrong in ways that look right: the PO report's own "invoiced" column goes stale the moment someone keys an invoice after the report was run, which is how the same cost gets accrued and expensed in the same month.
Which journal entries still need a person
Some entries should not be generated by rule at all, because the number is a decision, not a calculation. Software can assemble the support for them, but a person sets the amount.
- Estimates. Allowance for doubtful accounts, inventory obsolescence, warranty reserves, bonus accruals that depend on a payout decision, impairments and contingencies.
- First-time and non-recurring entries. A new contract type, an acquisition, a one-off settlement. There is no history for a rule to learn from.
- Corrections of prior errors. The entry itself may be simple. Deciding how far back the error goes and how to present it is not.
- Post-closing and top-side adjustments. Entries made after the subledgers close, or outside the general ledger entirely, during financial statement preparation.
- Policy calls. Capitalize or expense, gross or net, which period a cost belongs to when the facts are unclear.
This list overlaps closely with what auditors look for. PCAOB AS 2401, the fraud standard for public company audits, lists characteristics of inappropriate entries: entries made to unrelated, unusual or seldom-used accounts, made by people who do not usually make entries, recorded at period end or post-closing with little or no description, made without account numbers, or containing round numbers or a consistent ending number. It also points at accounts with significant estimates and period-end adjustments, intercompany transactions and accounts that have not been reconciled on time. If an entry fits that description, it belongs with a person.
How to set the review level for each entry
"Automated" should not mean "unreviewed". It should mean the review is sized to the risk of the entry. Three tiers cover most entry lists:
- Scheduled entries: batch approval with exceptions. The reviewer approves the batch and looks only at what changed from last month: a new line, a dropped line, an amount that moved. Set a variance threshold in both percent and dollars before you look at results, so a 2% move on a $900,000 entry does not slip through because the percentage looked small.
- Calculated entries: line-level basis check. Every line carries its basis (the PO, the invoice, the spend history) and the reviewer confirms the basis supports the amount. Under the materiality line, sample; above it, check every line.
- Judgment entries: full preparer and reviewer sign-off. The preparer documents the reasoning, the reviewer is someone other than the preparer, and the support stays attached to the entry.
Two rules apply across all three. The person who configures an automated rule should not be the only person approving its output. And every entry, however routine, should have a named approver somewhere in its audit trail.
A worked example: one received-not-invoiced accrual
Illustrative figures, not from a real company.
At month end the open PO report shows a $18,400 order for contract engineering services, marked received and not invoiced. A rule that trusts the report proposes an $18,400 accrual.
Checked against the AP register instead, the picture changes. The vendor's invoice for $6,200 of that work was keyed two days after the PO report was pulled. The correct accrual is the uninvoiced remainder:
| Amount | |
|---|---|
| Received per open PO report | $18,400 |
| Less: invoiced per AP register after the report date | ($6,200) |
| Accrual to propose | $12,200 |
The proposed entry debits professional services expense $12,200 and credits accrued liabilities $12,200, flagged to reverse on the first day of next month as a reversing entry. The reviewer sees the PO, the AP register line and the arithmetic in one place and approves it in under a minute.
Without the register check, the books would carry $6,200 of the same cost twice: once in the accrual and once in the posted invoice. Multiply that by every open PO on the report and the overstatement is material quickly. Next month, the reviewer's first question is whether the $12,200 reversed. An accrual that never cleared, with a fresh one booked on top, is the most common double count in an automated accrual process.
The controls automated entries need
Automating an entry moves the control point. Instead of reviewing each keyed entry, you are reviewing the rule that makes them and the population they produce. PCAOB staff made this explicit in their January 2025 Audit Focus on journal entries: auditors should consider fraud risk in entries processed through automated systems, "as the risk of management override of controls is not limited to journal entries processed manually." The same publication lists failing to test the completeness of the journal entry population among the common audit deficiencies.
In practice that means six controls:
- Change control on rules. A change to a template, a driver or a mapping is reviewed and approved like an entry, and logged with who changed it and why.
- A complete entry log. Every automated entry is identifiable as automated, with its source and run date, so the population an auditor pulls is complete.
- Support attached, not referenced. Each line links to the document or data behind it. "Per schedule" in the description is not support.
- Reversal tracking. Every entry flagged to reverse is checked the following period; failures surface as exceptions, not as next quarter's surprise.
- Exception routing. Anything the rule cannot support (thin history, a missing PO, a variance over threshold) goes to a person with the reason, instead of posting with a guess.
- A periodic look at the automated population itself. Run the AS 2401 characteristics against automated entries too: round amounts, period-end timing, seldom-used accounts and the system user posting entries it does not normally post.
For a fuller treatment of controls when AI is preparing the work, see internal controls for AI in finance.
How to start automating journal entries
- Export the last three months of entries. Pull every manual journal entry with its preparer, accounts, amount and description.
- Classify each recurring entry into scheduled, calculated or judgment, using the tables above.
- Pick the highest-count scheduled entries first. They are the lowest risk and free the most time. Leave judgment entries where they are.
- Define support and threshold for each. Write down what source each entry comes from and what variance sends it to a person.
- Run in parallel for one close. Prepare the automated entries alongside the manual ones, compare, and fix differences before switching. Then move scheduled entries to batch review and start on calculated ones.
Most teams find the month-end close entry list is mostly scheduled and calculated entries by count, with a smaller set of judgment entries carrying most of the risk. That split is the case for automation: it gives reviewers time back for the entries that need them.
Where journal entry automation breaks at scale
Template-based automation works until the entry list grows faster than anyone can maintain the templates. Each new entity, vendor and contract adds rules, drivers drift, and the exceptions that a rule cannot handle pile up in someone's inbox. The data-driven entries, the ones with the most value, are also the ones that need someone to pull the report, check it against the register and attach the support every month.
Adopt is AI native accounting and bookkeeping software where agents do that preparation inside the systems a team already runs. Agents prepare the reconciliations and the supporting work for the close, propose the entry with its evidence, and route anything they cannot support to a person instead of guessing. Each output carries a provenance file of the source data, computations and decisions behind it, and approval requires a named reviewer. The model never touches the numbers: it writes code that people can review, and deterministic code does the math. Nothing posts without a human sign-off. The free month-end accrual proposals skill shows the approach on one entry type: it proposes received-not-invoiced and recurring accruals cross-checked against the AP register, each with a basis and a reversal flag for a controller to approve.
Book a demo to see agents prepare your entry list with the support attached, or sign up free to connect your books and start. For the wider close, see the financial close automation guide.
FAQs
Related Articles

AI Pilot for Your Finance Team: A 90-Day Plan That Protects the Close


AI Finance Security Questions: The 20 Your IT Team Will Ask, With Answers

See it running on your workflows
Automate your accounting workflows

